Interior and Measurements

Looking At replacing some aged and weathered parts. Water entry and regulator need to be replaced due to 30+ years of sun damage. Replacing hand pump sink with something more modern/electric. Hot side can be plugged into the regulator and cold side can be electric pump facing. May 3D print a separate base for the faucet to mount to /w switches for other 12V hardware.

Under Hood Specs

Unreadable Vacuum Diagram

Replacing Water Regulator

Entry Hole Dimensions

Faucet Dimensions

Faucet Holes

Strap Width

Strap Nylon Webbing

Stove and Sink, Strap

Strap measurements

Collapsed Roof + Straps

Dropping the engine back in

The Engine is back in the engine bay, /w the Resealed L43 4 speed transmission and side linkage. Have the gas tank pulled, being cleaned at the moment. Waiting for a rebuilt distributor since the original may have a damaged diaphragm. New Fuel pump and lines ready to go back in once the rust is […]

Toyota 20R engine started

We reinstalled the gas tank and got a gallon or two of gas in the tank. We then did a compression test, and confirmed compression stroke /w top dead center on the first piston. Reinstalled all new Silicone vacuum lines and Placed the timing angle at 13* (high altitude) and turned the 20R engine over! […]

Engine Transmission Pull

With a cheap harbor freight hoist the 20r engine and R43 transmission have been pulled. The block crank and head will be taken to a local shop to get bored honed and rebuilt. Cylinders didn’t look to bad for 80k miles. Since the Chinook had a blown head gasket, my guess is that it overheated […]

Interior and Measurements

Grant Kohler

You might be interested in …

Dropping the engine back in

Toyota 20R engine started

Engine Transmission Pull

Leave a Reply Cancel reply