You might be interested in …

Window Vents 3D Printed

I was able to re-create the flimsy sun damaged weep hole vents that were originally on my 1977 Toyota Chinook. All 8 print in about 2 hours /w 1.75mm ABS plastic filament and .1mm layer height on my Reprap Prusa i3. I’ve published the part on Youmagine

Read More

Maiden Voyage!

Got the Chinook over to the DMV and registered! Still waiting on front brakes to show up. Still outlining the work that needs to be done on the door frame and sealing/re-framing the roof. The sink faucet needs to still be installed, and a base 3D printed to replace where the hand pump faucet was.

Read More

Fuel System & Lines

The rear door seal has been replaced on the outer side the inner door needs to be completely pulled out of the Chinook looks like welds need to be broken. Replaced all the old rubber vacuum lines with silicone ones, color-coded some of the important ones yellow. De-rusted and repainted the fan guard, as well […]

Read More

Leave a Reply