Rear Drum Brakes

Replaced rear wheel cylinders and brake pads including hardware. Ran into an issue where the passenger side rear wheel for some reason was a millimeter or so off and had to lightly file down for the replacement part to fit.

The original wheel cylinders look way cooler since they have to old school Toyota logo on them. But they are super rusty, could rebuild them if i wanted to.

You might be interested in …

Dropping the engine back in

The Engine is back in the engine bay, /w the Resealed L43 4 speed transmission and side linkage. Have the gas tank pulled, being cleaned at the moment. Waiting for a rebuilt distributor since the original may have a damaged diaphragm. New Fuel pump and lines ready to go back in once the rust is […]

Read More

Gas Tank Cleanup

Im letting the gas tank soak in a bunch of vinegar. It will get a Baking Soda scrub after soaking for a few days, which should get rid of the acid and remaining rust. I will be installing New Hoses and fuel pump once its clean and re-lined and painted. I used the old rubber […]

Read More

Fuel System & Lines

The rear door seal has been replaced on the outer side the inner door needs to be completely pulled out of the Chinook looks like welds need to be broken. Replaced all the old rubber vacuum lines with silicone ones, color-coded some of the important ones yellow. De-rusted and repainted the fan guard, as well […]

Read More

Leave a Reply