I was able to re-create the flimsy sun damaged weep hole vents that were originally on my 1977 Toyota Chinook. All 8 print in about 2 hours /w 1.75mm ABS plastic filament and .1mm layer height on my Reprap Prusa i3.
Window Vents 3D Printed

I was able to re-create the flimsy sun damaged weep hole vents that were originally on my 1977 Toyota Chinook. All 8 print in about 2 hours /w 1.75mm ABS plastic filament and .1mm layer height on my Reprap Prusa i3.
The rear door seal has been replaced on the outer side the inner door needs to be completely pulled out of the Chinook looks like welds need to be broken. Replaced all the old rubber vacuum lines with silicone ones, color-coded some of the important ones yellow. De-rusted and repainted the fan guard, as well […]
Worked on outlining the changes i need to make to the ignition. This includes the replacement of points to Pertronix electronic ignition. Got a replacement Accell coil, and confirmed that its resistance/voltage allow for the removal of the white resistor. It supports higher voltage, like the flamethrower coils. Otherwise the voltage is too low for […]
Replaced rear wheel cylinders and brake pads including hardware. Ran into an issue where the passenger side rear wheel for some reason was a millimeter or so off and had to lightly file down for the replacement part to fit. The original wheel cylinders look way cooler since they have to old school Toyota logo […]